Orion Car Audio Car Stereo System 2009 11 1 User Manual

Remote Power Adapter  
Wiring Guide  
Model ORRPA  
Connections and Installation Tips  
1. Connect the RED wire to a constant (+) 12 volt  
source. This can be the memory wire for the  
head unit (check to see if the radio is code-  
protected before cutting or unplugging the  
memory wire) or the (+) 12 volt battery terminal  
of the amplifier.  
6. The trigger delay is controlled by input volt-  
age on the GRAY wire. A low voltage input  
will increase the delay to a maximum of three  
seconds, at (+) 12 volts the delay drops to about  
one second.  
2. Connect the BLACK wire to ground. The radio  
chassis or amplifier ground terminal are gener-  
ally good locations for this connection.  
3. The BLUE wire should be connected to the am-  
plifiers or signal processors that are being con-  
trolled be the Remote Power Adapter. It supplies  
a (+) 12 volt output rated at 1 amp, with a one  
to three second delay when triggered by signal  
on the GRAY wire.  
Note: If the adapter is being triggered by a  
speaker output, it will stay on (along with the  
devices it controls) for a short period after the  
head unit is switched off. This is due to the  
stored energy of a typical chip output and can-  
not be avoided. To prevent turn-off transient  
noise we recommend that the adapter be trig-  
gered by a dedicated remote output of the head  
unit whenever possible.  
4. The GRAY wire may be connected to any wire  
from the head unit that measures above (+) 5  
volts when the unit is on and below (+) 3 volts  
when the unit is shut off. This includes power  
antennas, amplifier remote outputs (typically  
(+) 12 volts but may be as low as (+) 5 volts in  
some OEM systems), or speaker outputs. A high-  
powered deck will normally supply between (+)  
6-7 volts DC at the speaker output; this is suf-  
ficient to trigger the Remote Power Adapter.  
Use this method for applications where the head  
unit lacks any dedicated switched outputs or it is  
easier to access a speaker terminal.  
7. By combining two or more adapters, sequen-  
tial turn-on of several devices can be achieved.  
This will permit a signal processor to power up  
after the head unit followed by the amplifier(s)  
thereby preventing turn-on transients in the  
signal chain from reaching the speakers.  
8. The Remote Power Adapter will drive up to 1  
amp of load at (+) 12 volts. If multiple devices to  
be switched exceed the 1 amp limit use a second  
adapter. For single-device loads that exceed 1  
amp a small relay (DEI part # 8616) can be used.  
The Remote Power Adapter is a better way to  
switch audio components since it eliminates the  
large inductive voltage peaks that a relay gener-  
ates.  
5. The GREEN LED built into the ORRPA lights after  
the delay period, indicating that the remote  
output is triggered.  
ORRPA 2009-11  
1
 

Milwaukee Cordless Drill 5337 20 User Manual
MRV Communications Network Card EM316E1 User Manual
MTD Snow Blower 500 Series 600 Series User Manual
National Computer Hardware CP3BT26 User Manual
Nikon Camera Lens AF S VR NIKKOR User Manual
Nortel Networks Switch 2000 User Manual
Northern Industrial Tools Impact Driver 120203 User Manual
Onkyo Stereo Receiver HT RC330 User Manual
Onkyo Stereo Receiver TX NR616 User Manual
Panasonic Answering Machine kx t1450 User Manual